 |
Machined from Solid Bar Stock 303 Stainless Steel.
Close tolerance Specification..
High tolerance consistent wall thickness required.
8 weeks Lead-Time including the reverse Engineering from casting.
Bar Stock product was more consistent then original cast design.
|
 |
Inconel 718 AMS 5383 Investment Casting
Nickel plated bores
Target and flow testing requirements.
Tolerance within .0002”
Conical Seal
|
 |
Inconel 738 Investment Casting
Close tolerance requirements throughout part.
Turned/Milled and ground in house.
|
 |
Aluminum 6061-t651
Made from solid due to thin walls.
5 axis machining
Reverse Engineering Casting from bar stock
|
 |
Machined from Nitronic 60
Close finish Specifications
Full profile NPT Threads
|
 |
Aluminum 2024 A250/11
Machined from a solid
Multi-Axis Machining
Parts family up to 12” Dia. O.D.
|
 |
Wasp. Alloy Material
Strict flatness requirement of .0005 all over part
13” Diameter O.D. x 1/16” Thickness
Fabricated in house through in house developed processes.
|
 |
Bearing retainer made from PH13-8 is a Martensitic Stainless Steel.
CNC turning and 5 axis milling.
Material supplied in a heat treated condition.
Part is then hardened and ground to proper flatness.
|
 |
Rough Machining Heat treating
Part made from a Vacuum Remelt 4340 material
Shot peened to improve Durability and surface finish.
Offset bores jig ground to within .0003”
|
 |
Reverse Engineered Assembly from a damaged casting.
Hog Out from a solid piece of Aluminum.
Our engineering department was faced with a situation where there was no print or any Engineering data from the previous design.
|
 |
Titanium Forging was re-Engineered and made from a solid bar.
This resulted in lower cost a product with superior strength than the original.
Part requires deep hole drilling.
|
